Oxford EVO HotGrips ATV – V9 Dual Thermister Switch

Introduction

Quad grips for 22 mm diameter handlebars, perfect to keep warm and enjoy your route in winter.

Oxford ATV HotGrips EVO EL423 heated grips, with V.9 heat controller, offer 5 levels of heat. The temperature selector is integrated into a separate switch to facilitate discreet installation on your motorcycle.

The grips and the thumb warmer are controlled by two individual thermistors (channel 1 and 2 respectively).

Heating component pattern distributes more evenlyMind the heat from the thumb warmer and the cuffs to the driver’s entire hand.

When the motorcycle is turned on, the controller will provide maximum power to the grips and thumb warmer so that they reach the programmed temperature, so the time it takes to achieve this is now shorter. Afterwards, the smart thermistor will regulate the flow of electricity to keep the cuffs and heater at a constant temperature.

If the grips are connected to the motorcycle’s ignition, the switch will remember the last programmed setting and activate it.

Specifications:

• Colour: black.
• Minimum and maximum length of the cuffs: from 120 to 130 mm.
• Contains fixing rings and end caps for the handlebar.
• Thumb warmer strong> (designed to be installed over the throttle lever).
• Temperature selector by separate switch.
• 5 temperature levels: 45, 42’5, 40, 37’5 and 35 C.
• Built-in smart thermistor for temperature control.
• Auto-off.
• Waterproof connectors.
• Low energy consumption.
• 12 v power supply.
• Maximum grip due to the relief of the diamond pattern.